Good price
Professional solutions
Phone consultation+370 657 86 751
16×320 mm Stainless Steel Anchor with M10 Internal Thread INK-320-M10 is a fixing element designed for installing brackets and other suitable components through façade insulation into a load-bearing substrate. Manufactured from A2 / AISI 304 stainless steel, the anchor provides good corrosion resistance under normal indoor and outdoor conditions.
The 320 mm long design allows a fixing point to be installed through an insulation layer. The M10 internal thread, with a depth of 35 mm, provides a connection for compatible bolts, brackets and other mounting components. The anchor is installed using suitable chemical anchoring resin, taking into account the substrate material, expected loads and installation requirements.
1. Prepare the fixing location: Mark the intended fixing position and assess the façade insulation thickness and load-bearing substrate material. Verify that the selected anchor and chemical anchoring system are suitable for the expected loads.
2. Drill the hole: Drill a hole through the insulation into the load-bearing substrate, following the diameter and depth requirements of the selected chemical anchoring system. Thoroughly clean the hole according to the resin manufacturer's instructions.
3. Prepare the chemical resin: Prepare compatible chemical anchoring resin according to the manufacturer's instructions. For hollow substrates, use a mesh sleeve and installation method only if approved for the selected chemical anchoring system.
4. Insert the anchor: Inject the required amount of chemical resin into the prepared hole and insert the anchor according to the manufacturer's installation procedure. Ensure correct anchor positioning and the required embedment depth in the load-bearing substrate.
5. Allow the resin to cure: Wait until the chemical anchoring resin has fully cured. Curing time depends on the resin type, substrate and ambient temperature. Do not apply loads before curing is complete.
6. Install the component: Attach the compatible bracket or other mounting component to the anchor's M10 internal thread. Use an M10 bolt of suitable length and follow the manufacturer's tightening requirements.
Important: The specified maximum insulation thickness of 220 mm is a technical parameter of this anchor. However, suitability for a particular installation depends on the load-bearing substrate, embedment depth, chemical anchoring resin and expected loads. Before installation, assess potential thermal bridging and compression of the insulation layer. For load-bearing handrails, balcony components and other safety-critical applications, the fixing solution must be verified against applicable design requirements and manufacturer specifications. In coastal environments or other locations with increased chloride exposure, the suitability of A2 / AISI 304 stainless steel must be assessed separately.
What is the 16×320 mm anchor with M10 internal thread used for?
This anchor is designed for fixing brackets and other suitable components through façade insulation into a load-bearing concrete or masonry substrate. The installation method must be selected according to the substrate properties and expected loads.
What is the maximum façade insulation thickness for this anchor?
The specified maximum façade insulation thickness is 220 mm. Before installation, verify the required anchor embedment depth and the requirements of the selected chemical anchoring system.
Is chemical anchoring resin required for installation?
Yes. The anchor is designed for installation using compatible chemical anchoring resin. Resin type, hole dimensions, embedment depth and curing time must follow the manufacturer's technical specifications.